TSSC System Manual
https://alpha.adt.com/help/65[11/12/2018 9:42:14 PM]
point is opened. When off, no chime will
sound.
not meet the requirements of UL 2017.
READY
Pressing
READY
before arming the system will
display all open protection zones.
Holding the key for 5 seconds will display all
zone descriptors.
[#]
Permits arming of the e system without using a
security code.
Your system may or may not allow for
“Quick Arming”.
Special
Function
Keys
Panic keys can be programmed to be activated
with a special function key. The key and its
functionality is determined by your panel’s
capability.
Arm & Disarm the System
Setting the System
The TSSC continuously displays your current security status. Changes to the system, such as going from
armed to disarmed may take up to 20 seconds to update on the display. Pressing [*] will update the
display immediately.
Arming and Disarming
Your system arms in four modes: Away, Stay, Instant, and Max. The terms and their functions are detailed
in the section above.
To arm the system, enter your [security code] + the numeric key associated with the code.
To disarm the system, enter your [security code] + [OFF].
Quick Exit
A Quick Exit allows for a delayed exit after setting the alarm. Once the interval is set, a user can set the
alarm while still having sufficient time to exit the premises before the alarm is entirely activated. Quick Exit
is not possible in Instant Mode.
To set Quick Exit, enter [user code] + one of the arm modes.
For example, [user code] + [STAY].
To cancel Quick Exit once the delay has expired (and the system is fully armed), enter [user code] + [STAY]
+ [STAY].
Chimes and Beeps
