C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
31
The operation follows:
1) Input Z14.
2) Press the
key and the system starts searching downwards; after that, the cursor locates
address Z. If you press the
key to search upwards, the system can’t find instruction word
Z14, and alarms.
◆
To return to the start of the program
In editing mode and program display page, press the Reset key
and the cursor returns to
the start of the program.
Method
2: Searching
(a) Select the editing mode;
(b) Press the Program key
to enter the program display interface;
(c) Type address key
and number key
(the current program
is number 5);
(d) Press the
key and the cursor returns to the start of the program
Method
3
: scanning
(1) Select the editing mode to enter the program display interface;
Program
Data=
Manual mode
Method
1
Program
Data=
Editing mode
Not searched!
