C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
33
3) To delete the characters in input buffer: If X1000 has been input in the input buffer, press the Delete key to delete
the last character, then, the character in the input buffer is X100, and press again to input X10.
6.2.
Deleting program
6.2.1
DELETING SINGLE PROGRAM
The operation follows:
1)
Select the editing mode to enter program page;
2)
Type address key
and number keys
in sequence,
3)
Press the Delete key
to delete program O0001.
6.2.2
DELETING LINES FROM THE PROGRAM
Delete from the character where the cursor locates to %semicolon. The operation is invalid if the cursor locates
the name of current program.
The operation follows:
1)
Select the editing mode, and move the cursor to the start N character to delete
Program
Data=
Manual mode
Program
Data=
Editing mode