C N C 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
41
7.4.1
ABSOLUTE VALUE INPUT OF KNIFE COMPENSATION
1. Enter the bias interface, move the cursor to the compensation number to edit the bias value and
press the MDI
key to enter the MDI mode;
1
Press the address key
or
, and then input the compensation value (allows radix point)
2
Press the
key to display the compensation on the LCD.
For example: Input -20 in the X value of bias number T0202, and the operation follows:
In the MDI mode, type X-20 and then press the
key to have the following page:
Knife compensation parameters
Fixed knife alignment
MDI mode
7.4.2
INCREMENT INPUT OF KNIFE COMPENSATION
1. Enter the bias interface, move the cursor to the compensation number to edit the bias value
and press the MDI
key to enter the MDI mode;
2. Press the address key
or
, and then input the compensation value (allows radix
point)
3. Press the
key to display the increased value of the increment.
8.
Automatic operation
8.1
Automatic running
Select the program with searching or scanning method
Searching (
take searching program O0001 as an example)
A. Select the Auto mode;
B. Press the Program
key to enter the program page;
C. Press the address key
and number keys 0, 0, 0, 1 in sequence;
D. Press the
key to display the searched programs on the LCD (the system alarms if
the program doesn’t exist).
S/N
Data
Position: