XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-41
Figure 3.2.4.4.1 Speed parameter
1. System limited speed: the speed limit the machine can reach. The speed limit of this system is
12000mmpm, and it cannot be modified.
2. System max. speed: the max. speed that machine can reach while processing. The actual speed is the
product of the max. speed and the speed percentage.
3. High jog speed: high speed according to speed level.
4. Middle jog speed: middle speed according to speed level.
5. Low jog speed: low speed according to speed level.
6. Startup/corner
speed:
the
corner speed during cutting.
7. Fast/Slow home Speed: when home, the machine moves at high home speed at first, and decelerates and
stops when hitting the switch, and then moves back at low home speed until signal disappears.
8. Creep speed: the machine tools needs to move forward slowly during perforation, which is called
creeping. The creeping speed is set with this parameter and is shown as speed percentage.
9. On the right of the Speed parameter interface you can set the acceleration of the machine and the speed
of the corners within different cut mode.
Note: during auto cutting, the system only allows a processing speed lower than original speed; during manual
cutting, when the moving speed is lower than original speed, the system will run at original speed.
3.2.4.5
F5
Exit
Press F7 under the main interface to enter Exit interface as shown below:
Summary of Contents for ADT-HC8200
