Unit Installation
NetVanta 4660/5660 Series
26
Copyright © 2019 ADTRAN, Inc.
617004660F1-34B
5.
UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as
mounting options, supplying power to the unit, and installing option cards. These instructions are
presented as follows:
•
•
•
Supplying Power to the Unit on page 29
For information on configuring a specific application, refer to the configuration guides provided on the
or the
AOS Command Reference Guide
.
Electronic modules can be damaged by static electrical discharge. Before
handling modules, put on an antistatic discharge wrist strap to prevent damage to
electrical components. Place modules in antistatic packing material when
transporting or storing. When working on modules, always place them on an
approved antistatic mat that is electrically grounded.
To prevent electrical shock, do not install equipment in a wet location or
during a lightning storm.
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta are:
To access the CLI of the NetVanta, you will also need a PC with terminal emulation
software and a console port cable. Instructions on how to access the CLI are
available in the quick start guide shipped with your unit or online at
.
•
Ethernet cables
•
Network cables (module dependent)
•
Phillips-head screwdriver (rackmount applications only)
•
Drill and drill bit set (wallmount applications only)
•
The NetVanta 4660/5660 Series is intended to be installed, maintained, and
serviced by qualified service personnel only and should be installed in a
restricted access location as described in UL/IEC 60950-1.
•
Ethernet cables are intended for intrabuilding use only. Connecting an
ADTRAN unit directly to Ethernet cables that run outside the building in which
the unit is housed will void the user's warranty and could create a fire or shock
hazard. To connect an ADTRAN unit to Ethernet cables that run outside the
building, ADTRAN's Ethernet Port Protection Device (EPPD) (P/N 1700502G1)
must be connected between the unit and the outside plant cable. Use of any
Ethernet protector other than ADTRAN's for this purpose will void the user's
warranty.
