background image

2

617600139F1-13A

Features

The features of the 825-v6 gateway include the following:

■ XGSPON network uplink
■ Subscriber interfaces

♦ 2.5 Gigabit Ethernet (RJ-45) interface
♦ 4x Gigabit Ethernet (RJ-45) interfaces
♦ 3x3 802.11ax @2.4GHz
♦ 4x4 802.11ax @5GHz
♦ 2x voice (RJ-11) interfaces

■ Remote activation and deactivation
■ Remote firmware upgrades
■ Remote OMCI management as per ITU-T G.988

Installing the 825-v6 Gateway

The following are guidelines for basic installation of the 825-v6. 

Package Contents

■ ADTRAN’s 825-v6 WiFi 6 XGS-PON gateway

12V DC power adapter

Prior to Installation

Before installing the equipment, inspect the gateway. If damage has occurred during shipping, file a claim with the carrier, and then contact ADTRAN 
Customer Support. For more information, refer to the product warranty available online at 

https://adtran/wp_support_warranty

Required Tools

Standard technician tools and, if installing the gateway on a wall, a #2 Phillips-head screwdriver, are required for installing the 825-v6.

Mounting Options

There are two options to install the 825-v6: desktop and wall mount. Be sure to route and secure the fiber and cables in a manner that will prevent 

damage. These options are described below.

Desktop Installation

The 825-v6 can be placed on a desk or table. The following table shows the recommended minimum distance (in feet and meters) between the gateway 
and household appliances to reduce interference.

NOTE

g

Refer to the national, state and local electrical codes for the requirements for power, grounding, wiring, and installation methods. 

CAUTION!

f

The product is intended for indoor use only. Ethernet, POTS cables, and attached equipment are intended for use within the same building with 

equipotential bonding, and not intended to be placed in separate buildings or structures. Failure to deploy as described could result in permanent 

damage from lightning or other electrical events and voids the warranty.  Furthermore, all connections from outside of the building, such as old POTS 

wiring, must be disconnected prior to use.

Household Appliance

Recommended Minimum Distance (in feet and meters)

Microwave ovens

30 feet / 9 meters

Baby monitor – analog

20 feet / 6 meters

Baby monitor – digital

40 feet / 12 meters

Cordless phone – analog

20 feet / 6 meters

Summary of Contents for 617600139-13A






Reviews: