background image

Safety and Regulatory

841-t6 Mesh AP QSG

6

6SDG841T6-13A

■ IEC 62368-1
■ EN 62368-1, AS/NZS 62368.1
■ RoHS Compliant

Safety and Regulatory

Regulatory Compliance

This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation 

of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against 

the end-user by the applicable National regulatory authority.
This product's firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all options described in this 

user's guide may not be available in your version of the product.

Europe – EU Declaration of Conformity

Products bearing the marking comply with the following EU directives:

■ EMC Directive 2014/30/EU
■ Low Voltage Directive 2014/35/EU
■ WEEE Directive reference: 2012/19/EU

If this product has telecommunications functionality, it also complies with the requirements of the following EU Directive:

■ RED 2014/53/EU

Compliance with these directives implies conformity to harmonized European standards that are noted in the EU Declaration of Conformity.
For indoor use only. Valid in all EU member states, EFTA states, and Switzerland.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP 

in the frequency range of 2454 - 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.

FCC Requirements for Operation in the United States

FCC Information to User

This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifi

-

cations will invalidate all applicable regulatory certifications and approvals.

FCC Guidelines for Human Exposure

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and 

operated with minimum distance of 20 cm between the radiator and your body.

CAUTION!

f

Connect the DC power input to an approved Limited Power Source (LPS) power supply ONLY.

This product is intended to operate in ambient temperatures up to 40°C. 

It is recommended that an external AC Surge Protection Device be installed at the AC input connection to the local AC-Powered 

product. The Surge Protection device should provide L-N, L-G, and N-G protection. It is also recommended that the device 

contains a visual 'GOOD' indicator.

■ The product is intended for indoor use only. Ethernet, Voice, and attached equipment are intended for use within the same 

building with equipotential bonding, and not intended to be placed in separate buildings or structures. Failure to deploy as 

described could result in permanent damage from lightning or other electrical events and voids the warranty.

NOTE

g

This product meets the following compliance requirements:

■ This equipment contains no parts that can be serviced by the user.
■ This product meets EU RoHS Directive. Refer to www.adtran.com/environmental for further information on RoHS/WEEE.
■ This product is NRTL Safety Listed to the applicable UL/CSA Standards.
■ This product has also been evaluated to applicable international standards as indicated by CE, UKCA, and RCM marking.
■ The AC branch circuit socket-outlet must be installed near the equipment and must be easily accessible.
■ The RJ-45 jacks are not used for telephone line connection.

Summary of Contents for 841-t6









Reviews: