ADTRAN
BroadCloud Analog Gateway Configuration Guide
4
Online Resources
Additional ADTRAN configuration guides are available online in the ADTRAN support forums.
https://supportforums.adtran.com
Recommended documents include:
•
Security Best Practices for AOS Products
•
AOS Command Reference Guide
•
Product-specific Hardware Installation and Quick Start Guides
Accessing the CLI
Console Port
Access the AOS CLI via the
CONSOLE
port. To establish a connection to the NetVanta unit
CONSOLE
port, you need the following items:
•
PC with VT100 terminal emulation software
•
Straight-through serial cable with a DB-9 (male) connector on one end and the
appropriate interface for your terminal or PC communication port on the other end
1. Connect the DB-9 (male) connector of your serial cable to the
CONSOLE
port
located on the rear of the unit.
2. Connect the other end of the serial cable to the terminal or PC.
3. Provide power to the unit as appropriate. Refer to the product specific hardware
installation guide at
https://supportforums.adtran.com
for more details.
4. Once the unit is powered up, open a VT100 terminal session using the following
settings: 9600 baud, 8 data bits, no parity bits, 1 stop bit, and no flow control. Press
<Enter>
to activate the AOS CLI.
5. Enter
enable
at the
>
prompt and enter the Enable mode password when prompted.
The default password is
password
.
Telnet or SSH
You can also access the CLI from a Telnet or SSH client. In order to do this, you must know the
IP address of the AOS device. If you do not know the unit’s IP address, you must use the
CONSOLE
port to access the CLI. To access the CLI using a Telnet or SSH client, follow these
steps:
1. Connect the unit to your PC, using an Ethernet cable connected to the GIG 0/1 Gigabit
Ethernet port on the rear of the unit.
2. Open a Telnet or SSH client on your computer and enter
10.10.10.1
. If you have
changed your unit's IP address, you will need to enter that address.
3. For SSH, log into the unit using the default login (
admin
) and password (
password
). For
Telnet, only the default password (
password
) is required.
4. Enter
enable
at the
>
prompt and enter the enable password when prompted. The
default password is
password
.
Summary of Contents for BroadCloud
Page 1: ......
