FCC-Required Information
TRACER 6000 Series Split System Manual
6
Copyright © 2005 ADTRAN, Inc.
612806320L1-1B
FCC Output Power Restrictions
The FCC does not require licensing to implement this device. License-free operation in the industrial,
scientific, and medical band is documented in FCC Rules Part 15.247. It is the responsibility of the
individuals designing and implementing the radio system to ensure compliance with any pertinent FCC
Rules and Regulations.
This device must be professionally installed
.
Exposure to Radio Frequency Fields
The TRACER 6320 is designed to operate at 5.8 GHz with 100 mW maximum transmit power.
This level of RF energy is below the Maximum Permissible Exposure (MPE) levels specified in FCC OET
65:97-01. The installation of high gain antenna equipment in the system configuration may create the
opportunity for exposure to levels higher than recommended for the general population at a distance less
than 15 feet (4.6 meters) from the center of the antenna.
The following precautions must be taken
during installation of this equipment
:
•
The installed antenna must not be located in a manner that allows exposure of the general population to
the direct beam path of the antenna at a distance less than 15 feet (4.6 meters). Installation on towers,
masts, or rooftops not accessible to the general population is recommended; or
•
Mount the antenna in a manner that prevents any personnel from entering the area within 15 feet
(4.6 meters) from the front of the antenna.
•
It is recommended that the installer place radio frequency hazard warnings signs on the barrier that
prevents access to the antenna.
•
Prior to installing the antenna to the TRACER output, make sure the power is adjusted to the settings
specified in section 2 of this manual.
•
During antenna installation, be sure that power to the TRACER equipment is turned off in order to
prevent the presence of microwave energy on the coaxial connector.
•
During installation and alignment of the antenna, do not stand in front of the antenna assembly.
•
During installation and alignment of the antenna, do not handle or touch the front of the antenna.
These simple precautions must be taken to prevent general population and installation personnel from
exposure to RF energy in excess of specified MPE levels.
The TRACER 6000 Series split system ships with an integral low-gain antenna for some
international applications. The integral antenna has an effected isotropic radiated power
(EIRP) of less than +33 dBm.
Verify the antenna installation meets all regulations specified in the National Electric
Code (NEC) Article 810.
