32
2.1 Position of the stove / distance requirements
Distance requirements will only apply if the wood burning stove is to be placed close to flammable materials:
Distance to flammable
material (cm)
To the sides
(A)
Behind the stove
(B)
Distance to furniture
(C)
Corner position
(D)
Above the
stove
Aduro 22
70
7.5
100
-
50
Aduro 22.1 Lux
40
7.5
100
10
50
Aduro 22.3 Lux
70
7.5
100
-
50
Aduro 22.4 Lux
70
7.5
100
-
50
Aduro 22.5 Lux
70
7.5
100
-
50
If the stove is positioned against a brick wall or other non-flammable material, there are no minimum distance
requirements. To facilitate cleaning and for the best use of the convection air, we recommend that you keep
a distance of approximately 5-10 cm to the wall.
If the wood burning stove is to be placed on a flammable material such as a wooden floor or carpet, it must
be placed on a non-flammable floor hearth. The floor hearth should extend for at least 30 cm in front of the
stove and 15 cm on each side measured from the opening of the combustion chamber.
2.2 Pipe connection
Please ensure that all local rules and regulations are complied with, including CE marking of the flue pipe.
Additionally, distance requirements to flammable material for the pipe must be respected.
A flue pipe with an internal diameter of 150 mm should be used for all Aduro stoves.
The stove leaves the factory with the flue outlet mounted on the top. If you require the flue outlet on the back,
break off the cover plates positioned at the top of the back of the stove. Exchange the exhaust connector
(from the top outlet) with the cover plate from the rear outlet. Mount the cover plate from the rear outlet to the
top outlet. The top outlet is finished with the plate that lies in the ashpan. You may benefit from putting a slim
gasket between the flue on the stove and the flue pipe.
The wood burning stove must be installed on a floor with the adequate load-
bearing capacity. If the existing construction does not meet this requirement,
appropriate adaptation measures must be taken (e.g. a load-distributing plate).
