If you use the function "Heat Level" on the app and want the stove to restart automatically
on pellets when the wood has burned out, you can set the Aduro Hybrid on standby mode
with just 1 click on the button (see illustration). The stove will now be in standby mode and
await a smoke temperature below 100 degrees before it starts the pellet combustion and
ignites again. However, if you use the function "Desired Room Temperature", the Hybrid will
start automatically again when the smoke temperature is below 100 degrees.
IMPORTANT!
If the door to the combustion chamber is open for more than 3 minutes, the pellet combustion will shut
down and must be started again by pushing
ON/OFF
. The stove starts when the smoke temperature is
below 100 degrees. If the stove
flashes
green
ON
, it means that the stove will start, but is waiting for the
smoke temperature to be below 100 degrees C or timer.
When you want to switch off the pellet burner, push the
ON/OFF
button. If you open the stove door during
operation, the red
ALARM
will light. If you close the door before 3 minutes, the pellet burner goes back to
ON
mode automatically.
3.4 How should I use my Aduro H1 & H3 LUX?
The Aduro H1 & H3 LUX is intended for
intermittent
combustion. This means that each stoking should burn
down to embers before new logs are added.
In order to obtain the best possible combustion, you should regulate the effect/heat output with the fuel.
Burning small logs provides more powerful combustion than burning large logs as the surface area is greater
and more gas is released. The amount of wood in the combustion chamber is another factor that affects
combustion. The optimum combustion is achieved by adding two pieces of logs. If you want an enhanced
effect, you can add more logs. The nominal heat output is reached by burning approx. 1.5 kg per hour,
divided between 3 pieces with a length of approx. 21 cm.
If you experience problems lighting the fire or the fire dies after a short time, it can be due to the following
reasons:
•
The fire wood is not dry enough. The fire wood should have a moisture content of max. 18%.
•
There is a negative pressure in the house.
•
The smoke outlet from the outside may be blocked from sooth. This can occur after chimney
sweeping. Control the smoke outlet.
•
The used amount of wood may have been too small. Therefore, the embers were too weak and cold
to light the next load of wood.
3.5 Recommended fuels
3.5.1 Wood and wood briquettes
Wood that has been stored indoors has a tendency to become too dry and will burn too quickly. We
recommend that you fell the wood in the winter, when a lot of the moisture in the wood will have been drawn
down into the roots. In order to achieve optimum combustion, the wood’s moisture level should not exceed
18 %, which roughly corresponds to storing the wood under cover outdoors for one year. The moisture level
of the wood can be measured using a moisture meter or by applying washing up liquid to one end of the log
and blowing air in the other end. If the wood is dry enough, soap bubbles will appear. The wood should be
chopped into logs with a diameter of approx. 10 cm and a log length of max. 39 cm.
Summary of Contents for EN13240
Page 25: ...25 9 Pr vningsattest...
