62
If the hybrid stove can’t connect while other electronic devices in the house work well with your Wi-Fi, it is
due to the fact that the hybrid stove requires a stronger Wi-Fi signal than other electronic devices.
You can find a guide on connecting the stove to Wi-Fi in our
3.4 Register your stove on Aduro Cloud
We recommend that you register your hybrid stove to our cloud
connected to your Wi-Fi router. When you register the stove on Aduro Cloud, you will gain direct access to
your stove’s data and settings. You can find information and statistics on combustion, temperature, pellet
consumption and times of ignitions. You can also see and adjust the stove’s settings and check potential
alarms.
Registering your stove on Aduro Cloud is also helpful for us and the serviceman in the case you are
experiencing issues with your stove
– or regarding the mandatory service visits. You can find instructions for
logging into the cloud in our
4. Firing in the hybrid stove
During transportation, it may happen that the baffle plate in steel falls out of place. Therefore, before using
the stove, please make sure that the baffle plate is properly placed on the hooks to achieve optimum
combustion and to prevent soot on the glass.
Important safety information
•
The hybrid stove gets hot during use and therefore it should be treated with all necessary caution.
•
Never keep easily combustible fluids such as petrol in the near of the hybrid stove.
•
Never use easily combustible fluids to light the fire in the hybrid stove.
•
Never use wood with nails and other objects that can damage the auger carrying the pellets.
•
When lighting a fire and adding new wood logs, it is important to get the fire burning fast. If the fire
does not start quickly and wood only smoulders, it can cause strong smoke formation and in worst
case cause an explosive ignition of the flue gasses, which can damage the hybrid stove.
•
The brazier must not be removed during use with either wood nor pellets (doesn’t apply when
conducting a fast cleaning under the brazier to clean out ash and cinders).
•
The door should be kept closed while the stove is in use. While lighting the fire, the door can
stand ajar for the first few minutes.
•
The pellet operation stops if the door has been open for 3 minutes.
•
When putting logs in a hot stove, you must always open the primary air intake and make sure that
the wood ignites within 2-3 minutes. If the wood does not ignite, add some ignition products, and
ignite them manually. Please make sure that the flames are burning steadily for the first 10
minutes before you leave the stove.
•
Never empty the ash pan when the stove is warm. Embers may still be found in the ash pan for up
to 24 hours after the fire has gone out. Please wait to empty the ash pan until you are sure that
there are no embers in the ash.
•
In the event of a chimney fire: Close all the dampers on the stove and call the fire-fighting service.
