66
2. Place a log of wood crosswise in the combustion chamber and put 2 firelighters close to the log. Light
the firelighters and quickly put a new log close to the firelighters and several small logs at an angle
above it. Air must be able to reach the firelighters, but the logs should be touching to “warm” each other.
3. Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there are
distinct, visible flames and the fire has taken hold, close the primary air intake.
4. When there are distinct, visible flames and the fire is burning well, close the primary air (see section
4.1.1.1).
4.2 Firing with pellets
If you use the hybrid stove with both wood and pellets, the damper for pellet burning must be open (i.e.,
pulled forward). When opening the bottom door, you can see the small, black damper to the left below the
combustion chamber.
If you only wish to use the hybrid stove with pellets, close the damper for wood burning to achieve optimum
effect of the pellets (i.e., push the damper all the way in).
4.2.1 Filling of pellets
Place the enclosed funnel in the opening of the pellet box and add the pellets. Use a poker to spread the
pellets evenly in the pellet container to make use of the entire capacity (approx. 13 kg of pellets).
By the first use, the augers must be filled with pellets:
Open the door to the combustion chamber and remove the brazier (the black cast iron cone with Aduro logo)
so you can see the auger and the pellets being fed by the auger. Close the door again. Press and hold the
auger button, and the augers will start transporting the pellets (only when LED lights yellow at OFF). After
approx. 12 minutes where you press and hold the auger button, the auger pipe will be filled with pellets.
Release the button when the pellets are about 2 cm under the top edge of the auger pipe. The put the
brazier back.
4.2.2 Lighting the fire with pellets
Before the pellet function of the stove is turned on, you should ensure that there are enough pellets
underneath the brazier. You can do this by moving the brazier to the side. If there are pellets up to around 2
cm under the edge of the auger tube, there are enough pellets. You can now put the brazier back in place.
Remember to check that it is placed correctly and fits tightly. Then, you can turn on the stove.
Ignition via the stove’s control panel
Push the ON/OFF button and wait until the ON button displays a constant green colour. The lighting of the
fire will then start automatically. During ignition the combustion chamber will be filled with smoke until the
pellets are fully ignited. After approx. 6 minutes flames should appear. Normal use should be achieved after
15-20 minutes.
The control handle will get warm when the stove is in use. Please use the
glove provided when you operate the stove.
