SERVICE MANUAL
ENGLISH
Adinity™ 17 ST / 20 ST / 20 D / X 20 D / X 20 C / X 24 D
9096982000(2)2009-06
53
RECOVERY WATER SYSTEM
VACUUM SYSTEM MOTOR DISASSEMBLY/ASSEMBLY
Disassembly
If the tank (21) contains recovery water:
1.
Drive the machine to the appointed recovery water disposal area.
•
(For
•
Adinity™ 20 D, X 20 D, X 20 C, X 24 D
) Turn the ignition key (80) to “0”.
(For
•
Adinity™ 17 ST, 20 ST
) Turn off the switches (71) and (73).
Empty the recovery water tank (21) with the hose (16).
•
Drive the machine on a level loor.
2.
• (For
3.
Adinity™ 20 D, X 20 D, X 20 C, X 24 D
) Turn the ignition key (80) to “0”.
(For
•
Adinity™ 17 ST, 20 ST
) Turn off the switches (71) and (73).
Disconnect the battery connector (12).
4.
Grasp the handle (41) and carefully lift the tank (40).
5.
Remove the screws (A) and recover the washers.
6.
Remove the motor cover (B).
7.
Remove the ilter (C) and the gasket (D).
8.
Remove the motor (E), the sound-deadening pipe (F) and the sound-deadening panel (G).
9.
Disconnect the electrical connector (H) of the motor (E).
10.
Check the eficiency of the gasket (I) and, if necessary, replace it.
11.
Assembly
Assemble the components in the reverse order of disassembly, and note the following:
12.
If necessary, clean the ilter (C) before assembling it (see the procedure in the relevant paragraph).
•
Summary of Contents for Adinity 17ST
Page 2: ......
