Packing
Always pack your EPSILON 8 rib on rib, so that the plastic rods at the
leading edge lie flat on each other at the same height. This will pre-
serve the EPSILON 8’s long life. It will also maintain the fast and relia-
ble inflating qualities at takeoff.
To reduce wear at the wing centre you should randomly change the
lane which carries the final chordwise fold. Always store your wing in a
dry and dark place.
Care and maintenance
Ultraviolet light, heat, humidity, sea water, aggressive cleaning agents,
unsuitable storing and physical abuse ( dragging across the ground )
speed up the ageing process.
The life of a paraglider can be extended significantly by observing the
following advice:
§
Allow a wet or damp glider to dry by leaving it completely unpacked
at room temperature, or outside in the shade.
§
If the glider gets wet with salt ( sea ) water rinse it thoroughly with
fresh water.
§
Clean the glider only with fresh water, and a little neutral soap if
necessary. Do not use solvents under any circumstances.
§
If the glider has been subjected to increased stress ( such as a tree
landing ) have it examined by an expert.
§
Regularly remove sand, leaves, stones and snow from the cells.
Openings with Velcro closures are provided at the wing tips for this
purpose.
§
Do not leave the glider out in the sun unnecessarily before and after
flight ( UV light ).
§
Do not subject the packed glider to excessive temperature fluctua-
tions, and do ensure adequate air circulation to prevent condensa-
tion forming.
§
Do not drag the glider across the ground.
§
When landing, make sure that the canopy does not fall on its leading
edge.
Maintenance, repairs and care
29
Summary of Contents for EPSILON 8 23
