FORM NO. 041410 / HYDRO-RETRIEVER 2067 -
21
MAINTENANCE
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SQUEEGEE MAINTENANCE
After each use, clean the squeegee tool and check the blades for damage. The rear squeegee blade has 4 working edges. Turn the blade so a clean,
undamaged edge points toward the front of the machine and against the floor. Replace the blade if all 4 edges are necked, torn or worn to a radius.
If the squeegee leaves water in the middle of its path or at both ends of its path, it probably needs to be adjusted.
To adjust the squeegee...
1
Park the machine on a level floor and lower the squeegee.
2
Loosen the four Squeegee Adjustment Bolts
(A)
.
3
Pivot the squeegee tool until the squeegee blades touch the floor evenly across the entire width of the squeegee tool. Then tighten the four
bolts.
4
Adjust the height of the Squeegee Support Wheels
(B)
so the squeegee blades contact the floor at a 45
°
angle when they are bent over to their
“operating position”. Move the wheels up to lower the squeegee or down to raise the squeegee.
A
B