INSTRUCTIONS FOR USE
ENGLISH
MICROMATIC 13E
9097508000(2)2009-05
13
MACHINE TRANSPORT/PARKING
To transport/park the machine, proceed as follows.
Turn off the machine by pressing the switch (6).
1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7).
2.
Push the machine with the handlebar (2) and keep the brush/squeegee-holder deck slightly lifted.
3.
Lift the machine and turn the parking lever (24) to position (24b).
4.
TANK EMPTYING
WARNING!
To avoid spilling the water (for example during an abrupt machine maneuver), drain the recovery tank (16) at the
end of every cleaning cycle.
Use the transparent cover with vacuum grid (15) to check if the recovery tank (16) is full.
CAUTION!
If the recovery tank (16) is not emptied when full, the vacuum system ejects the excess of liquid through the air
outlets, thus dampening the
fl
oor.
When the recovery tank (16) is full, empty it according to the following procedure.
Recovery tank emptying
Turn off the machine by pressing the switch (6).
1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7).
2.
Drive the machine to the appointed disposal area.
3.
Lift the brush/squeegee-holder deck and turn the parking lever to position (24b).
4.
Check that the solution tank (14) is not full, otherwise perform steps 9 to 11 and following.
5.
Open or remove the solution tank (14a or 14).
6.
Open the transparent cover (15) and remove the recovery tank (16).
7.
Open the recovery tank drain plug (19) and empty the tank.
8.
Then, rinse the tank with clean water.
Solution tank emptying
Perform steps 1 to 4.
Carefully remove the solution hose (17) from the quick coupling (11).
9.
Remove the solution tank (14) from the 2 mounting pins (26).
10.
Empty the solution tank (14) through the plug (18) or the hole of the solution hose (17).
11.
Then, rinse the tank and clean the solution hose
fi
lter (25) with clean water.
12.
