Advanced Air UK Ltd
Burrell Way
Thetford
Norfolk IP24 3QU
Tel: 01842 765657
Email: Projects@advancedair.co.uk
2530 CE Series
Smoke Fire Damper
Due to continuous product development Advanced
(U.K.) Ltd reserves the right to change any
information without prior notice
Date
Issue
Sheet
Spec Number
April 2018
C
12 of 34
TS2530CE-01
G:\PRODUCTS\DMP - 2500 Series\05 Product Data\2530\Tech Sub\2530CE\TS2530CE-01 Technical Sub Rev C.docx
Dampers with the actuator at the top will be coded
DTOP
, examples are shown below:
Top Horizontal (
RH, AMH
)
Top Left (
RH, AMVD
)
Top Right (
RH, AMVU
)
Multi-section dampers with three sections will have a centre section with vertical blades. The centre
section can have the actuator at the top and at bottom. These configurations would be coded as
COMT
(External drive outer sections/horizontal blades and central sections drive on top/vertical blades) or
COMB
(External drive outer sections/horizontal blades and central sections drive on top/vertical
blades). Where dampers are 2 sections high and coded
COMT
or
COMB
, there will be actuators at the
top and bottom on centre sections.
The actuator will protrude
over the spigot by 50mm in all
cases.
The actuator will protrude
over the spigot on all dampers
420mm nominal duct height
and smaller.
The actuator will protrude
over the spigot on all dampers
580mm nominal duct height
and smaller.
