TM
10
Diagram of Inflation Chambers
3.3 Inflating
IMPORTANT
: Before inflating, check to be sure that the kayak is completely assembled. Inflate
your kayak in the following order.
Failure to follow these instructions may cause damage to
your kayak. Do not over inflate.
1. Partially inflate chamber 1 until the kayak begins to fill out or appears to be half way inflated
then close cap. Check to be sure the valve is in the inflate position (
See Figure 1
).
2. Proceed to chamber 2. Inflate chamber 2 until AdvancedFrame™ tube is firm to touch. Close
closed caps on chambers 1 and 2 tightly. Chamber 1 and 2 are separate chambers but
equalize in pressure because they are inside a fabric cover. Ideally you want to put half of the
air in chamber 1 and half in chamber 2. That way if you suddenly lose pressure in one
chamber you should have another chamber as a safety.
3. Inflate chamber 3 “floor” (using proper hose fitting). Twist valve open to inflate and twist
closed when complete
(Figure 2)
. Fill with air until firm (1 psi
ONLY
).
CAUTION
:
Do not
over inflate!
4. Inflate thwart/foot brace (chamber 4) until firm (1 psi
ONLY
). Attach to Velcro on side tubes.
This chamber can be moved forward or backward when paddling solo.
5. Inflate chambers 5 and 6 for desired deck lift.
6. Make sure all valves are closed tightly and properly.
7. Finally, Insert Plastic Bow and Stern forms into pocket on bow and stern
(Figure 3)
.
