Table 3‑1. Soft key functions (Continued)
Soft Keys
Description
Down arrow
• Toggles devices for selection
• Decreases a parameter value
DIS
or
ESC
• Detects newly connected sensor heads
• Returns to the previous screen
When changing settings with the converter box display, you first must make a
selection from the available devices to be parameterized. Once you select a device to
be parameterized, you can set new values for individual parameters as needed.
☞
Important
Pressing the
ESC
soft key at any time during parameterization will cancel the
current step and go back to the previous step.
To Parameterize Devices Using the Converter Box Display
1. If necessary, press the
DIS
soft key to detect any newly connected sensor
heads.
2. Press the
PAR
soft key to initiate parameterization.
3. Press the up-arrow and down-arrow soft keys to toggle between the available
devices.
☞
Important
Master
= Converter box
4. Press the
PAR
soft key to select the desired device to be parameterized.
5. Repeatedly press the
PAR
soft key to toggle between the available parameters
for the selected device until the display shows the desired parameter.
6. Press the up-arrow and down-arrow soft keys to adjust the value of the
parameter as desired.
7. Press the
ENT
soft key to set the new parameter value.
8. Repeat steps 4 through 6 to set new values for additional parameters for the
selected device as needed.
9. Press the
ESC
soft key to return to device selection, and then repeat steps 2
through 8 to parameterize additional devices as needed.
10. Press the
ESC
soft key to return to the main screen.
PARAMETERIZATION FLOWCHART
The following figure shows the parameterization process using the converter box
display.
Advanced Energy
®
Impac
®
Series 600 Pyrometer
57010228-00C
Installation, Setup, and Operation
3‑16
