Advanced Poly-Packaging Ti-1000ZR Operation Manual Download

Page: 22 / 55

Settings can only be adjusted while the
printer is in

Setup

mode. An error will

be displayed on the baggers touch
screen. After adjustments and test are
complete, return the printer to

run

mode by pressing <setup>. Do the same
to take the printer out of

run

mode.

The Printer Settings screen features
rectangular indicators that display the
printer’s status:

•

Power OFF

indicates that the printer is off. This box will also display “Self-Test” when the

printer is first turned on and “Ready” during startup if an error does not exist.

•

No Label / Label

indicates whether or not a label has been downloaded.

This box will also

display “Error,” “Printing” and “No Ribbon” during various stages of operation.

•

ReprintBuffer

: If “ReprintBuffer” is displayed, the printer is continuously printing a preset

amount of the same label. If “ReprintBuffer” is displayed in grey, the reprint function is not
activated. If “New Label” is displayed, a new label has been downloaded. If “StoredLabel” is
displayed, a label has been recalled from stored memory.

The second column on the Printer Setup screen serves as a further indicator of the printer’s status. This
box will display

Reprint OFF

, if the reprint function has been turned off,

Reprint ON

if the reprint

function has been turned on and

OverWrite

if previous label settings are overridden.

This screen also displays the downloaded label parameters, including the

Darkness

setting, the

Speed

setting, the

Quantity

setting and the

Length

setting. The Darkness, Print Speed, Quantity and Length

parameters are set up in the label software. They are displayed on the OFL Printer Setup screen for
informational purposes. However, the Darkness and Length settings can be changed on this screen.

Print Delay

: This setting causes the nip rollers to compress first, thus delaying the print head from

lowering. This will ensure that the film is captured and ready to start feeding before the print head lowers.
Increasing this delay time will cause loss of production. To change this setting, press the

Print Delay

button, enter a value on the numeric keypad and press the

ENT

button.

PrHead Del

: This setting is the amount of time, in seconds, before the machine cycles again after

completing the previous cycle. To change this setting, press the

PrHead Del

button, enter a value into the

numeric keypad and press the

ENT

button.

Darkness

: Darkness can be set between 1 and 30. Darkness settings can be set in your label software,

but can also be overridden by adjusting the Darkness setting on the OFL Printer Setup screen. Increase the
Darkness setting to improve print quality. A typical setting is 20. To change this setting, press the

Darkness

button, enter a value into the numeric keypad and press the

ENT

button.

The

Stored Label

button will expand the options to include

Label #

and

Length

Figure 3-4