Epoch-M1C RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document
Page 14 of 38
** If a wireless modem is not connected, skip steps 12 through 13 and
proceed to step 14.
9. Provide SNMP Information
Type in the Site ID and the Manager IP address as given to you by the
Wireless Provider. Once both the parameters are typed in, you must click
“Set” for it to be executed.
10. Check the Modem Connection
Verify that the
Auto Connection box is checked.
11. Click on Install
After the first three steps, click on “Install.” This installation process will
normally take less than a minute.
** Please refer to the “Epoch-M1C Quick Start Guide” for any questions or
problems that you may encounter during this installation process.
If a modem is not connected to the repeater and you click the “Install”
button, the following pop-up window will appear:
If you choose to continue with the RF portion only, simply click “Yes” and
the installation process will resume again.
12. Check the Front LED Panel
Check that the Power LED is on (Green) and the Alarm LED (Red) is off.
** If the Alarm LED is on, refer to Section 2.3 on page 25.
** You can go to the Status Menu of the Epoch-M1C Software to view the
basic parameters of the repeater once the repeater has installed
successfully.
