Epoch-M1C RF Repeater
User Manual V1.1
Advanced RF Technologies, Inc. Proprietary Document
Page 25 of 38
2.2
Using the Epoch-M1C Software
2.2.1
Changing Parameters
In changing the parameters of the repeater using the Epoch-M1C
Software, note that the values entered into the Epoch-M1C Software are
limited to the ranges and modes specified in the Menu Structure section
as explained in Section 2.1 on page 15.
The chart below shows the parameters that can be changed and the
location of each parameter in the Control Menu Structure. The asterisk
“*” denotes parameters that apply to both uplink and downlink.
2.3
Alarms
All the various alarms that are supported by Epoch-M1C can be viewed by clicking
the “Alarm” button on the Status Window. If a soft or hard fail alarm should occur,
the corresponding alarm box would be highlighted in yellow or in red respectively.
In order to find out what is causing the alarm(s), simply place the mouse cursor over
the highlighted yellow or red alarm box
(Note: only applicable to some of the alarms)
and a message will appear, displaying the threshold value and the current measured
value. To update the window, click the “Refresh” button.
Control Menu
General
Setting
Alarm
Setting
Reboot
Factory Setting
Manual Gain Control*
AGC Level Control*
Uplink Tracking Offset
Periodic Time
Date & Time
RSSI*
Input Overload*
Figure 12 - Variable Parameters in the Epoch-M1C Software
