INSTRUCTIONS FOR CELTIC MOTOR USED IN
THE MYSTIC Z-BOX MODELS
IMPORTANT NOTES BEFORE YOU START:
1.
PLEASE READ EACH INSTRUCTION CAREFULLY AND COMPLETELY BEFORE PERFORMING THE
ACTIONS DESCRIBED IN THE INSTRUCTION.
2.
The Celtic Motor used in the Mystic Z-Box Motorized Screen is equipped with an AUTOMATIC
THERMAL CUTOFF MECHANISM that acts to prevent the motor from overheating. Depending
on the outdoor temperature, if the motor is run continuously for 3-5 minutes it will shut down
automatically. If this occurs, it will require approximately 20 minutes to cool down.
3.
FOR EACH INSTRUCTION, IT IS EXTREMELY IMPORTANT THAT YOU FOLLOW THE STEPS AND
BUTTON SEQUENCES EXACTLY AS DESCRIBED OTHERWISE THE PROGRAMMING WILL NOT BE
ACCEPTED. THIS IS BECAUSE THE MOTOR IS SET TO ACCEPT ONLY EXACT SEQUENCES OF
BUTTON COMBINATIONS FROM THE REMOTE. IF YOU DO NOT PERFORM THE STEPS EXACTLY,
YOU MAY HAVE TO RESET THE MOTOR/REMOTE AND START OVER FROM THE BEGINNING. THE
INSTRUCTION TO RESET THE MOTOR/REMOTE IS THE LAST INSTRUCTION BELOW.
4.
ONLY ONE motor/remote combination can be programmed at any point in time. If you are
installing MULTIPLE UNITS at the same job site, you will have to turn off power to all units
except the one you are programming.
5.
Power surges or static electric discharges caused by bad weather or other circumstances may
cause the motor and remote to become unpaired and if the motor has electronic limits those
may also be lost. Ensuring that the unit is properly grounded may help to prevent this from
occurring.
6.
If you are hard-wiring the motor to the electric circuit, it is recommended that you install a
switch in that circuit and in the vicinity of the unit so that the power to the unit may be turned
on and off in the event that the unit has to be reprogrammed because of power surges caused
bad weather or other circumstances.
955 Patrick Industrial Ct
Winder, GA 30680
Phone: 678-926-9700
Fax:
678-288-7924
