Advanced Technology Video ED2916, Setup Manual

11 

Display Button 

Pressing the 

DISPLAY

 button toggles between different display formats.  The available 

formats are: PIP, 2x2, 1+5, 1+7, 3x3 and 4x4. 

Panic Button 

Pressing the 

PANIC

 button starts panic recoding of all camera channels, and displays   on 

the screen.  Pressing the button again will stop panic recording. 

IR Remote Control

ID Button 

Camera Buttons 

Sequence Button 

Freeze Button 

Arrow Buttons 

Menu Button 

Playback Buttons 

Panic Button 

Layout Button 

Zoom Button 

PTZ Button 

Enter Button 

  Alarm Button 
  PTZ Control Buttons
  Back Up Button 
  Calendar Button 

ID Button

If a DVR System ID is set to 0, the infrared remote control will control that DVR without 
any additional operations.  If the system ID is 1 to 16, you must to press the 

ID

 button 

and then press the number button (1 to 16 (+10 & 6)) in order to control that DVR.  If 
the System ID of two or more DVRs is set to 0, those DVRs will react to the infrared 
remote control at the same time. 

Camera Buttons

Pressing the individual camera buttons will cause the selected camera to display full 
screen.  Buttons are also used to enter passwords. 

Sequence Button

When in the Live Monitoring mode, pressing the 

SEQUENCE

 button displays live channels 

sequentially. 

Freeze Button

Pressing the 

FREEZE

 button freezes the current live screen. 

Arrow Buttons

These buttons are used to navigate through menus and GUI.  You can also use them to 
change numbers by highlighting a number in the menu and using the 

Up

 and 

Down 

arrow 

buttons to increase or decrease the number’s value.  These buttons are also used to control 
Pan and Tilt when in the PTZ mode. 

When in the PIP display format, pressing the 

Up 

and 

Down 

arrow buttons moves the 

position of the small screen counter-clockwise and clockwise. 

Pressing the 

Left 

and 

Right 

buttons moves through screen pages in the Live Monitoring 

mode and Search mode. 

Menu Button

In the Live Monitoring mode and Search mode, pressing the 

MENU

 button displays the 

menu icons on the right edge of the screen.  Pressing the button again hides the menu 
icons.  During menu setup, pressing the button closes the current menu or setup dialog box.