Advanced Telemetry Systems, Inc. R4500S Reference User Manual R05-11-A
42
3.3.2 Starting a Stationary Scan - Variable Pulse Rate Transmitter
From the Main Menu, use the
or the
key to move the cursor to the
STATIONARY
position and press
“ENTER”
.
To change the numeric value, use the numeric digits on the keypad, or you can use the
and
keys to
increment the numeric value, up or down or to toggle between YES / NO selections. For the R4500S to accept a
value, press
“ENTER”
.
Moving the cursor with the
or the
will allow movement between screens or by pressing
“ENTER”
for the
last item in the window to proceed to the next window.
Screen
1
Continual:
The R4500S will continually scan through the selected frequency table.
Periodic:
The R4500S will scan through the selected frequency table and shut the power off
for a period of time.
Screen 2
The number entered here should represent the range of pulse rates you are using in your study. The available
period range allowed to be entered is between 400ms to 6000ms. The periods measured from signals that are
outside the entered range will be thrown out.
Screen
3
(A = Store Rate
or
Log Period
,
see below
)
Time Out:
The amount of time the receiver will stay on a Frequency while attempting to
detect a transmitter. If no transmitter is detected in the Time Out period, the
receiver will advance to the next frequency in its frequency table. This feature
allows faster scanning by truncating the scan time if no transmitter is detected in
the Time Out period. The user defines the parameter (Range = 001 – 300
seconds). Refer to section
14.0
for information on setting the Time Out value.
