7
Safety Features
■ Operate the unit only
- when in fault-free technical condition
- with all safety and protective features installed and fully
operable.
■ replace all damaged or faded Warning and Notice labels attached to the
unit immediately.
Site of installation
■ Install the unit in a dry, well-ventilated room.
■ Within close proximity of the sunbed
- do not store potentially explosive materials or containers ,
for instance, spray cans.
- smoking and open fire is prohibited.
■ Do not expose materials which tend to fade or get damaged when
exposed to UV light to the radiation emitted from this product.
Safety Instructions for Operation
Prior to each use of the sunbed, make sure that all controls are set up
correctly and all safety features are installed, for instance:
- sunbed acrylic
- top canopy acrylic
- facial filters
- exhaust air disposal
■ Do not block air entries or ventilation openings. Risk of heat damage!
■ Before and after each use of the sunbed, check unit for visible outer
damage or defects and remove immediately.
■ Any defects which might affect the safe operation of this unit must be
communicated to the operator or the person in charge immediately. Use
sunbed only after all defects have been corrected.
Safety Instructions for transport
■ Use only suitable and technically fault-free lifting and carrying devices
adequate to the load!
■ Do not stay close to or work below moving load!
■ Observe all standards and regulations for the prevention of accidents at
the workplace.
■ Transport dollies must be blocked and marked to prevent injuries
caused by transportation vehicles or the load.
