29
Installation of Assembly Plate
Put the assembly plate into its designated position.
- Fix the assembly plate with two thumb screws to the
groundplate.
- Plug in the connection cable to the main control board.
Assembly of sunbed bench
The rear side of the sunbed bench is reset for about 4″ into the rear column
and is thus supported by the column lengthwise. At the sides, the bench is
supported by the bench supports. There are two screws at the headend and
two screws at the footend.
Four persons carry the sunbed bench to the sunbed construction and
put it onto the bench supports.
Push the sunbed bench towards the rear column and let it into the rear
column.
Fix the sunbed bench with screws to the bench supports.
At the footend, put in the plug connection of the connection cable for the
body cooling fan.
