44
Example
The following example shows you how to change a set-up. If, for instance,
you want to customize the operating hours for low-pressure lamps, proceed
as follows:
Turn the mains disconnection switch into position “I”.
Push the following sequence of buttons:
– “Cooling top canopy”,
– “Facials”,
– “Cooling top canopy”,
– “AC unit”,
– “AC unit”.
You are now in the operator menue. The operating hours for low-pressure
lamps can be found under menue point “02”.
Push the “Music” button twice.
Menu point “02” is shown.
With the buttons “+” and “–” you enter the required value for the
operating hours, for instance 500.
With the “+” button you increase the value shown on the display.
With the “–” button you diminish the value shown on the display.
In order to get to the next menu point, push the button “Music”, until you
reach the required menu point.
In order to leave the operator menu, push the “Music”, button until you
have reached the last point in the menu.
The set-ups are saved automatically.
In this example, after the low-pressure lamps have reached a total of 500
operating hours, the display will show in the lower right corner a blinking
point which indicates that the pre-set max. operating hours for the low-
pressure lamps have been reached.
