68
Cleaning the dust filter mat:
– Push the top canopy open.
– Vacuum the dust with a vacuum cleaner.
Replacement of dust filter mat:
– Push the top canopy open.
– Pull out the dust filters.
Push the new dust filter into the groove between the two top front profile
grooves.
Dispose of used dust filters in compliance with applicable environmental
standards and regulations.
Dust Filter mat sunbed
At the sunbed, the dust filters sit in the headend and footend sunbed bench
supports. The filter mats are pushed between two grids. The inmost grid
can be removed.
Cleaning of dust filter:
– Vacuum the dust with a vacuum cleaner.
Repeat the same procedure at the other side.
Replacement of filters:
– Disconnect the unit from main supply with the mains disconnection
switch and secure with lock and key against accidental reconnection.
– Get a soft support ready for storage of the front cover.
– Loosen the two screws at the front cover.
– Slghtly lift the front cover and pull the holding brackets out of the slots
in the bench supports.
– Store the front cover on a soft support.
– Lift the inmost grid for about 5″.
– Pull out the grid with the dust filter mat in it.
– Remove the used filter mat.
– Put in the new filter mat.
– Reassemble the grid with the filter mat in it.
Repeat the same procedure at the other side.
Reassemble front cover again.
Put the holding brackets back into the slots at the bench supports.
Push the front cover against the sunbed bench and tighten with screws.
Dispose of used dust filter mats in compliance with applicable
environmental standards and regulations.
