70
Se the new starter into the holder (1).
Push the new starter clockwise for about 90° (2).
If necessary, clean the backlighting lamp with a soft leather cloth.
Put the backlighting lamp into the lampholder (3).
Turn the backlighting lamp for about 90° counter clockwise (4).
The backlighting lamp snaps into the lampholder. Take care that the
stamp on the backlighting lamp point into the direction of the viewer.
Reassemble the front cover.
Put the brackets into the slots at the bench supports.
Push the front cover against the sunbed bench and tighten with screws.
Replacing of backlighting lamps in the top canopy
The top canopy contains a backlighting lamp which highlights the acrylic
insert in the top canopy.
To replace the backlighting lamp and/or the starter, proceed as follows:
Disconnect the unit from the mains supply with the mains disconnection
switchand secure with lock and key against reconnection.
Pull out the holding bolt .
Lift the top canopy cover and support it.
