3
Hardware Installation and Operation
Inserting the phone into the
AdvanceCommunicator™ Cradle
Note:
When using iDEN Condor phones (i60, i90c and i95cl), remove
the logo lable on the back of the phone and replace it with the
logo lable supplied to allow connection of the phone to the
antenna in the cradle of the AdvanceCommunicator™. This will
provide access to the antenna connection socket of the phone.
1
Insert the phone into the AdvanceCommunicator™ cradle the same way
you insert it into the car kit cradle.
A
Line up the connector in the cradle with the connector receptable
on the bottom of the phone.
B
Press the phone down onto the cradle connector and the top of the
phone back into the cradle until it lock into place.
Note:
If the logo lable covering the antenna socket at the back of the
phone is not removed, the phone may not lock into it's correct
position in the cradle, and may cause communication and
operating problems.
2
If the iDEN phone is of the Falcon series (i730, i830, i833 and i860)
and you intend to use the AdvanceTecCommunicator™ base with the
AdvanceTec Communicator application, you will need to connect the
Audio Cable (included in your communication kit) between the audio
socket of the iDEN phone and the audio socket at the left side of the
AdvanceTecCommunicator™ base.
LED Indicator
The Communicator LED Indicator, display's the following status indications:
LED
Status
Flashing Red
Communicator cradle is empty, No phone inserted.
Red
The phone in the cradle is off. Battery charging.
Green
The phone in the cradle is on.
Flashing Green
Bidirectional communication mode is active.
Flashing Red and
Green
Adequate communication exists between the
Communicator and the computer via Data Cable.
Flashing Orange
Changing communication mode
