3
2. Position the Speaker on the mounting bracket and secure it by tightening the
thumbscrews. The mounting bracket is used to permanently mount the Speaker in
place while permitting it to be tilted to a desired angle.
Diagram 1
Installation
1. Mount the Junction Box beneath the dashboard on the passenger's side of the
vehicle or on the center side post between the front seats. It must be protected from
dirt and moisture and must be afforded adequate space for cooling. There must be
sufficient space to allow for connection of all cabling.
Diagram 2
2. Connect the Cradle Control Cable, the Speaker, Microphone, Power cable and
the PTT connectors to their respective corresponding connectors in the Junction
Box, as shown in Diagram 3 below.
Diagram 3
3. Route the cables out of the way to avoid physical or visual obstruction. Allow
sufficient slack in the cable to the PTT so that it does not interfere with the
movement of the gear lever.
Caution! The Hands-free unit should be used with a negative ground system only.