5
2. Position the antenna, maintaining a separation distance of at least 8 inches (20
cms) between the antenna and the body of any user and nearby person, to assure
compliance with the U. S. FCC regulations on RF exposure.
3. Connect the coaxial antenna cable connector to the antenna cable connector
from the Clam Cradle
Mounting of the PTT - To the gear lever or flat surface
1. To attach the PTT to the gear lever, strap the PTT around the gear lever (see
diagram 4 using the Velcro strip attached, with the cord facing down.)
2. To attach the PTT to a flat surface, remove the 2 screws from the bottom of the
PTT, which holds the Velcro strip in place. Remove the strips and replace the small
plastic part that held the strips in place with the larger flat plastic part supplied with
the PTT. Screw the new plastic part in place.
Diagram 5
3. Plug the connector end of the PTT into the Junction Box and dress the surplus
cord out of the way so that it is not visually or physically obstructive.
Caution! Make sure there is sufficient slack in the cable to allow the free movement
of the gear lever without stretching the PTT cable.
The Microphone
Selecting the correct position for the microphone is vital for the successful
performance of the hands-free unit.
1. The Microphone should be mounted either on the sun visor directly above, and
facing, the driver or on the headliner just above.
NOTE! The square on the leading edge of the microphone must face directly
towards the driver
Diagram 6