2.3
Remove Syringe and Feed Tube Enclosure
KEEP
these parts and screws to set aside and reinstall. A checklist is provided in
section 2.7.
2.3.1
Remove the Melter Cover
Use the 2.5 mm driver to remove and set
aside the four screws securing the melter
cover to the syringe holder (two on each
side).
2.3.2
Remove the Receiver Head
Loosen the receiver head thumbscrews and
remove the receiver head.
2.3.3
Remove the Syringe
Loosen the luer lock securing the feed
tube.
2.3.4
Remove the Feed Tube Enclosure
Loosen the thumbscrew securing the
lower feed tube enclosure.
Use the 2.5 mm driver to remove and
set aside the two screws securing the
upper feed tube enclosure.
Detach the
luer from
the feed
tube. Keep
luer to
clean and
reuse.
Discard
feed tube.
KEEP
KEEP
Page 12 of 28
Advanjet HM-2600 Hotmelt Jet Maintenance and Repair
3A6328A