2.4
Remove Mounting Plates and Top Cover
KEEP
these parts and screws to set aside and reinstall. A checklist is provided in
section 2.7.
BK-2001 or HK-2600
kit replaces these parts.
2.4.1
Remove Nozzle Plate (if present)
Going through the melter holder, use the 3 mm driver to loosen the two screws that secure the nozzle
plate. Remove the nozzle plate and set aside; nozzle plate screws will be removed later.
2.4.2
Remove the Dovetail Plate
Using the 3 mm driver, remove and set aside the
four screws securing the dovetail plate.
2.4.3
Remove the Mounting Plate
Using the 3 mm driver, remove and set aside the
three screws securing the mounting plate.
2.4.4
Disconnect Heater Block
Use the #1 PH to remove and set aside the two
screws securing the heater block.
Remove and discard the heater seal and
washer, and the jet compression spring.
2.4.5
Remove Heater Bearing
Use a cleaning swab or similar tool to push out
the heater bearing.
Leave any lubricant in place in the heater block;
Discard the bearing.
KEEP
DISCARD
3A6328A
Advanjet HM-2600 Hotmelt Jet Maintenance and Repair
Page 13 of 28