4.
Set the Jet Hammer Gap
4.1
Using the Gap Set Fixture
The following equipment is required:
Gap Set Fixture
0.050 in. hex wrench (stored in tool)
3 mm hex driver
Jet controller
NOTICE
The Gap Set Fixture is a sensitive calibration tool for maintaining the jet.
Except for calibrating the tool to zero and taking the measurement, the tip
protector should remain in place at all times. Without the tip protector in place,
the tip can be easily damaged, which would result in inaccurate measurements.
TIP PROTECTOR
0.050 IN. HEX WRENCH
3A6328A
Advanjet HM-2600 Hotmelt Jet Maintenance and Repair
Page 25 of 28