2.2
Pneumatic Connections
Main Air Supply:
Connect a filtered (40
-
micron filter or better
) and
independently
regulated main air source. It is highly recommended to place a drying system or
desiccant dryer in line with the main air line. A 6mm OD air tube with a slip connect
coupler is supplied to connect the HV-2100C to the main air supply. The main air supply
pressure should be between 70 and 100 psi (0.48 and 0.70 MPa).
Fluid Syringe Air Pressure:
The HV-2100C delivers fluid syringe air pressure through
clear 4 mm OD tubing that is attached to the receiver head and has a twist-lock
connector to the controller. The fluid syringe air supply should be at maximum 60 psi
(0.41 MPa); normal fluid pressure is usually between 10 and 50 psi (0.06 and 0.34 MPa).
Variations in the air pressure source can adversely affect the consistency of the drop
size.
Jet Air Pressure:
The HV-2100C delivers jet air pressure through black 6 mm OD
tubing with a quick-connect coupler to the controller and an air fitting for the jet. The jet
air supply must be clean and dry
and at a maximum pressure of 75 psi (0.51 MPa);
normal jet air operation is usually between 35 and 75 psi (0.24 and 0.51 MPa).
NOTICE
It is imperative that the air supplied to the HV-2100 is clean, dry, and free from debris and water. A 40-micron filter
is highly recommended. If the air is not clean and dry, serious damage can occur to the air solenoid valves.
Figure 2-2: HV-2100 Pneumatic Connections
Page 8 of 22
Advanjet HV-2100 Jet Setup and Operation
3A6244A
