Installation and Operation Manual S400 series
9
- 9 -
2.2.3. Resetting the MAX wind speed
To reset the maximum apparent wind speed, display the data on the lower display
and press and simultaneously for 2 seconds.
2.2.4. Measurement units
It is possible to choose from several measurement units to display apparent wind
speed, max. apparent wind speed, true wind speed and VMG. The table below
summarizes the various units displayed:
Data
Unit of measurement
Apparent wind speed
Knots
m/s
Miles/h
Beaufort
Max. apparent wind speed
True wind speed
Max. true wind speed
VMG
Knots
km/h
Miles/h
To change a unit of measurement:
On the lower display, select the information whose unit of measurement you want to
change, and press for 2 seconds.
The units for "apparent wind angle" and true wind angle" are always displayed in
degrees, and the battery voltage is always displayed in volts.
2.2.5. Setting the backlighting
The display and the 4 keys are backlit, with 4 levels of intensity. Level "0"
corresponds to backlighting switched off.
To control backlighting:
Press
to display the backlighting page, then press
to set the backlighting level from 0 to 4.
Pressing again on the
key sends the lighting level on the
bus to control backlighting on other device displays, or
automatic time out after 10 seconds for local setting.
