8
D.
Resetting Bowls
When AUTO RESET is enabled, this will allow the controller to automatically reset itself to the first
bowl after the last bowl has gone “low conductivity”. Set to Y will enable.
When disabled (Set to N), the controller will function as below:
When the controller is utilizing Bowl #2, it must be manually switched back to Bowl #1, presummably
after the solid chemical jugs have been changed. This can be done by:
1. Pressing the “VIEW” button and then rotating the “FUNCTION SELECT” knob two clicks clockwise.
The display will read “RESET TO BOWL #1”.
2. By rotating the “VALUE ADJUST” knob (either direction). The display will change to “SPRAYING
ON #1”. Chemical Bowl #1 will be used to start the new run cycle.
3. You may then press the “VIEW” button so the controller will return to the “run” mode.
(The controller will return to “run” mode after 3 minutes.)
E.
C-2 Menu Display Options
Press
VIEW BUTTON
to view menu
options
Press
VIEW BUTTON
to return to
run mode
Turn VALUE
ADJUST to change setting
Turn FUNCTION
SELECT to change menu
CALIBRATION
Turn VALUE
ADJUST to change setting
Turn FUNCTION
SELECT to change menu
SWITCH AT
Turn VALUE
ADJUST to change setting
Turn FUNCTION
SELECT to change menu
SPRAYING ON #1
Turn VALUE
ADJUST to change setting
Turn FUNCTION
SELECT to change menu
ZERO COND
Turn VALUE
ADJUST to change setting
Turn FUNCTION
SELECT to change menu
AUTO RESET? Y
Summary of Contents for SFS Series
Page 15: ...15 Notes ...