Customer Service 1-888-707-1880 7 Maurice Pincoffs Canada Inc.
©
2010
STEP 3
1. Insert the end of the tension control cable
(30)
to the C bracket of lower tension control cable
(53)
.
See Inset.
2. Connect the extension sensor wire
(36)
to the lower sensor wire
(66).
3. Attach the upright
(2)
into the bottom tube of the main frame
(1).
Secure with four
allen head bolts
(18
), four spring washers
(19),
four curved washers
(20)
which are pre-assemble
on the upright
(2). NOTE:
Please do not tighten the allen head bolts until you have all of the bolts
attached to the upright. When all bolts have been attached to the upright, you can firmly tightened
the bolts.
NOTE
:
it is necessary to insert the wires into the main frame once you have
attached the wires.
Be careful not to pinch the wires when you tighten all bolts.
STEP 4
1. Attach the left upper handlebar
(4L)
to the left lower handlebar
(5L).
Secure with two hex
bolts
(29)
, two curved washers
(28),
two spring washers
(27)
and two cap nuts
(26).
2. Repeat for the right side.
53
30
1
2
3
4
5
PDF created with pdfFactory trial version
www.softwarelabs.com
