S1 DISC PLAYER
_____________________________________________________________________
____
___________________________________________________________________
_____
Page 9
Remote control
1.
PRE/CD/DAC activates the different functions of each
ADVANTAGE product. CD and DAC activate the functions on S-1.
2.
EXT activates other ADVANTAGE products which
are connected via data-com.
3.
CMD gives access to the different commands
available on the selected unit.
4.
DISPLAY to get a quick overview of the current
settings in DAC mode.
EDIT changes the names of the inputs.
5.
SOURCE selects the digital input to be used.
6.
REC/PHASE Changes absolute phase on S-1 when in DAC mode.
7.
SKIP hold button: forward and rewind, push
button: track forward and rewind.
8.
SURR/MODE Turns resampling on and off in DAC mode.
9.
STOP push button to stop player.
OPEN hold button for a second to open.
10.
PLAY starts playing the CD.
11.
PAUSE
12.
VOL + /- volume settings (if activated).
13.
MUTE/REPEAT Silences the player in DAC mode. Activates the
repeat function in CD mode.
14.
BAL +/- balance settings (only on preamplifier).
15.
DIM adjusts the display brightness with a push
on the button.
STANDBY switches the unit between operation
and standby mode when you hold the button.
The volume control function
The S-1 is equipped with a state-of-the-art output stage with a built in volume control.
This enables the user to connect the S-1 directly to your power amplifier/s.
The volume control is controlled with the two buttons on the front panel or the two
buttons on the bottom left on the remote control.
Before you connect the S-1 directly to any power amplifiers you must verify that the
volume control is active. Press the DISPLAY button (4) on the remote until “VOL CTRL
ENA” or “VOL CTRL OFF” is shown in the right display. If the setting is “OFF” you must
switch it on by pressing either of the volume control buttons on the remote to toggle the
function to “VOL CTRL ENA” which means that the volume control is enabled.
As always, do not make any connections unless all equipment is switched off!
Source selection
In DAC mode on the remote control you can select what digital source the DAC will
encode.
To use the S-1 as a regular CD-player this setting is “CD” (factory default). By pressing
either of the source buttons you will cycle through the different digital inputs on the
player.
Absolute Phase
The S-1 is equipped with a function to change the polarity or absolute phase of the
signal output. This is done by pressing, in DAC-mod, the REC/PHASE button (6). The
right display will show the status.
