INSTALLATION
1. Select an indoor premise especially where there is free of direct sun rays, dampness and / or
rain to install this H2O AlkalinePlus System.
2. Install the System on a hard, firm surface or flat floor. Unbalance installation may cause noise
and trembling.
3. Install the System where there is good ventilation condition. Poor ventilation condition may
cause a reduction of cooling effect. For this purpose, please leave at least 10cm of space
between the System and the wall.
4. Connect the ¼” hose from the Water Supply Valve to the Water Inlet
Q
.
5. Detach the Top Cover
J
by removing the Screws
W
on the rear.
6. Lift the COLD Water Tank Cover and place it in a clean bucket.
7. Turn on the water supply and flush the filter cartridges until water runs clear.
(about 3 - 5 minutes)
8. Shut water supply and place COLD Water Tank Cover, and Top Cover back in position. Tighten
screws
W
of Top Cover.
9. Turn on water supply. Allow 10-15 minutes for the water to fill the HOT and COLD Water
Tanks. Make sure water can be dispensed from the HOT
F
and COLD
G
water tap before
proceeding to the next step.
10. Insert plug into a 13Amp socket, turn switch ON. The compressor will start working to chill
the COLD Water Tank.
11. Turn on HOT Water Heater Switch
L
to have hot water supply.
NOTE:
Cold Water
Tank Cover
Please allow at least a 5 minute interval turning on the Main Power Switch once it is off.
The COLD Water Thermostat
K
is already set for optimal performance in the factory.
Please do not adjust
the setting.
WARNING:
Do Not Plug
the System into the socket until water flows through both taps.
Water supply
valve
close
open
¼”hose to
System
H2O AP-T
Summary of Contents for Alkaline Plus H2O AP-S
Page 1: ......
