Advante H2O Plus, Owner'S Manual

5.   Fill in clean, drinkable tap water into the Water Filtration Container until it is full.
6.   Allow 10-15 minutes for the water to be filtered anf flow into the dispenser’s heating and 

      cooling compartments. Make sure water can be dispensed from the HOT 

G

 and COLD 

H

      water taps before proceeding to the next step.

7.   Turn on the main power switch, the compressor will start working to chill the COLD Water 

      Tank.

8.   Turn on the HOT Water Heater Switch 

M

.

9.   The POWER Indicator Light 

C

 will remain lit.

10. The HOT and COLD Water Indicator Light will light up intermittently with reference to the 

      present temperature.

NOTE:

Please allow at least a 5 minute interval turning on the Main Power Switch once it is off.
The COLD Water Thermostat 

L

 is already set for optimal performance in the factory.

Please do not adjust

the setting.

WARNING:

Do Not Plug 

the System into the socket until water flows through both taps.

PROPER CARE AND CLEANING

WARNING:

Always remove the plug from the electric socket before performing any 

                          maintenance or cleaning.  

General

1.  For best results, it is recommended to change the filters every 2650 litres or every 3 months, 
     whichever comes first.
2.  It is also recommended to wash the water containers, the filters and the dispenser every 
     month, including draining off all water within the dispenser by releasing water through the 
     Water Drainage Outlet 

P

. 

     Beware:

 Water flowing out can be very hot.

3.  The spilled water in the Drip Tray 

I

 must be removed and cleaned regularly.

Cleaning inner Stainless Steel COLD Water Tank 

1.  Remove the 2 screws (marked on page 2) on the rear side on 
     the Top Cover Assembly 

K

 with a Phillips Screwdriver.

2.  Lift up the Top Cover Assembly from the rear and detach 
     from the dispenser.
3.  Turn Part  S  (marked BLACK) 
     anti-clockwise and the Assembly will 
     come apart.
4.  Remove the Separating Disc by pulling up 
     vertically.
5.  Clean the Stainless Steel COLD Water Tank with a clean cloth 
     or kitchen towel. 

DO NOT USE any chemical or detergent.

6.  Position back all parts and secure Top Cover Assembly with 
     the screws at the rear side of the dispenser.   

Cleaning the Condenser Coil

We recommend that you move the dispenser away from the wall 
and vacuum or brush the coil 

Q

 at the rear fo the unit at least 4 

times a year. Some operating environments require more 
frequent cleaning. 

Stainless Steel 

COLD Water Tank

Separating Disc

Separating Disc 

Support

(

DO NOT REMOVE

)

Water Filtration

Container Holder

Part   S

Part   T

Top Cover