Page 44 / 56
DLT-V6210 Manual V1.00
Advantech-DLoG
11.3. Serial interface COM1
Max. 115,200 Baud (16550A compatible, 16 byte FIFO)
Supports EIA-232-E on external 9-pin D-Sub connection
ESD Level 4 protected (according to EN 61000-4-2)
11.4. Network adapter (10/100/1000)
DLT-V6210 is equipped with a 10/100/1000 Mbit network adapter with 10/100/1000 Mbit per second.
This adapter can be accessed via the bottom of the device and offers an RJ45 connection jack.
The RJ45 connection port has two integrated status LEDs and are assigned as follows:
Fig. 11.1: RJ45 network port
Left LED (green):
Right LED (orange):
LED off: no connection
LED off: no activity
LED on: connection (link)
LED flashing: activity
Problems with data transmission via LAN/Ethernet
If problems occur during data transmission over LAN/Ethernet (e.g. data is lost or not detected), the
cause of these problems may be the cable is too long. Depending on the cable layout and interference
from the environment, it may be impossible to use the cable length of 100 m given in the specification
(IEEE 802.3 standard). The solution here is to use a shorter cable.
11.5. USB
USB connection,
for example for
mouse, keyboard,
USB stick
2 x USB 2.0 Host
USB 2.0 Hi-Speed
Fused at 0.5 A per channel
ESD Level 4 protected (according to EN 61000-4-2)
11.6. Internal speaker, sound
DLT-V6210 is equipped with an internal speaker as standard (2 W).
The system messages from the industrial PC are output via this speaker.
The internal speaker can be configured in the audio settings of operating system in question.