iii
ACP-4010 User Manual/
用户手册/用戶手冊
Safety Instructions/
安全指示
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this equipment from the AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents.
4.
For plug-in equipment, the power outlet socket must be located near the equip
-
ment and must be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or letting
it fall may cause damage.
7.
Do not leave this equipment in an uncontrolled environment where the storage
temperature is under 0 °C (32 °F) or above 40 °C (122 °F), as it may damage
the equipment.
8.
The openings on the enclosure are for air convection. To protect the equipment
from overheating, DO NOT COVER THE OPENINGS.
9.
Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet and earth the connection. Secure the power cord
to a socket-outlet with a grounded connection.
10.
Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
11.
All cautions and warnings on the equipment should be noted.
12.
If the equipment is not used for a long period of time, disconnect it from the
power source to avoid damage by transient over-voltage.
13.
Never pour any liquid into an opening. This may cause fire or electrical shock.
14.
Never open the equipment. For safety reasons, repair of the device may only be
carried out by trained service personnel.
15.
If one of the following situations arise, get the equipment checked by service
personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according to
the user's manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
16.
The computer features a battery-powered real-time clock circuit. There is a dan
-
ger of explosion if battery is incorrectly replaced. Replace only with same or
equivalent type recommended by the manufacture. Discard used batteries
according to the manufacturer’s instructions.
(1) Risk of Explosion if battery is replaced by an Incorrect type. Dispose of used
batteries according to instructions.
(2) Risque d'explosion si la batterie est remplacée par un type incorrect. Mettre
au rebus les batteries usagées selon les instructions.
Summary of Contents for ACP-4010
