AIMB-C300 User Manual
8
2.4 The Standard Drive Bay
The standard drive bay of the AIMB-C300 can hold one 3.5" FDD or
Card reader (optional) and one Slim CD ROM.
1.Remove the top cover.
2.Detach the two screws holding the standard drive bay.(You could
remove the power supply first, it will easier to insert drive bay).
3.Lift off the standard drive bay.
4.Insert the drives into their proper locations in the drive bay and secure
them with the screws provided.(please refer to figure 2-4).
5.Connect the disk drive power and signal cables.
6.Install the standard drive bay and secure the top front cover with the
two screws.(please refer to figure 2-5)
Figure 2.3: Install the standard drive bay
Figure 2.4: Insert the drives
Summary of Contents for AIMB-C300
