FWA-5020 User Manual v01
_20161111
Copyright 2015 Advantech Co. Ltd. All rights reserved.
Page 84
For instruction on how to remove and install the top cover of the unit please refer to
section 3.3.
3.5.1
Disk drives
3.5.1.1 2
.5” HDD
You need:
-
a PH2 screw driver
a standard 2
.5” SATA HDDTo remove the HDD, proceed in the reverse of the
installation procedure in section 3.3.3.1:
5)
Detach the HDD power and SATA cables
6)
Remove the four screws on the corners of the HDD carrier plate and
remove the HDD carrier plate from the system
7)
Remove the HDD mounting screws and extract the HDD from the carrier
plate.
8)
Install a new HDD by following the instructions in section 3.3.3.1.
3.5.2
CMOS Battery
You need:
-
A BR2032 battery
Warning!
There is the danger of explosion if the battery is replaced incorrectly. Replace the
battery only with the same or equivalent type specified above.
Dispose of used batteries according to the manufacturer's instructions.
To replace the RTC’s battery located at B1, pull the spring clip securing the battery
forward with your finger tip. Please handle with care and do not bend the spring clip.
Then extract the battery vertically.
Figure 54: Pulling up the battery
Keeping the spring clip pulled towards you, insert the replacement battery.
Please make sure you insert the battery in correct polarity with the positive pole
facing on top and the negative pole facing the bottom. Trying to insert the battery with
