9
IPC-622 User Manual
Chapter 2
S
ystem
Setup
2.3.2
Dual CPU Card Installation on a Dual-Segment Backplane
Note!
Before installing two CPU cards onto a dual-segment backplane, we
recommend changing the system from ATX to AT mode by following the
instructions below
.
1.
Locate the green-black lines from the redun-
dant power supply, and retrieve the AT switch
from the accessory box.
2.
Connect the green-black lines to the AT
switch.
3.
Replace the ATX switch with the AT switch.
4.
Change the Power Supply Type setting for
each CPU card from “ATX” to “AT” before
installing the OS.
Summary of Contents for IPC-622 Series
